Note: This model is recommended for builders with experience in resin kit assembly

There is a 7 page written set of Instructions for assembling the kit (no illustrations) and an 11x 17 print of Chris Perrotta's drawing for reference.

Ordering information

Chair side parts and arm rest

Seat cushion placed on chair bottom and side
attached to see how these parts look together

Engine Housing components

Left and right sides of engine housing.
The seam has an overlap not a butt joint

Drive shaft parts and rail end flurishes

Detail of inside ball and 'lamp base'
Insulators at top


Clear acrylic tube is provided for the console, slot is cut for the lever.

Click on photos below to see enlargements


Fiddly Bits © 1998 Don & Mary Coleman
Web Site © 1999 Don Coleman
Web site created by Don Coleman
3727 W. Magnolia Blvd. #240 Burbank, CA 91505